PolyJohn Portable Mobile Hand Washing Sink Heated Water GrandStand PSW1-2100

Description

This listing includes the following:
One (1)
Portable Handwashing Sink
Brand:
Polyjohn
Part Number: PSW1-2100
Condition:
BRAND NEW!
Never Used or Installed!
This is a "scratch and dent" unit - the paper towel dispenser is damaged and not in working condition. There are multiple cracks in the sink bowl (see pictures) which may be able to be repaired with an epoxy or comparable material.
All serial numbers are intact, but obscured in the photos.
Buyer is responsible for confirming compatibility and usage for their specific application.
FREE Shipping in the United States!
USA Seller!
In-Stock! Ships within ONE BUSINESS DAY of payment!
Height
62 in / 157.5 cm
Width
18 in / 45.5 cm
Depth
22 in / 55.9 cm
Fresh Water Capacity
17 gal / 64.4 ltr
Gray Water Capacity
19 gal / 72 ltr
Pump Capacity (per stroke)
2 fl oz / 59.14 ml
Soap Dispenser Capacity
30 fl oz / 887 ml
Number of Single Dispenses
1088 / 1088
Paper Towel Capacity
1 Roll or 500 Single Fold (Georgia Pacific 23504)
Weight Empty
47 lb / 21.3 kg
Weight Full
189 lb / 85.7kg
Power Requirement
110V / 15Amp
Nominal Water Temp
110 Degrees F
Bowl Length
16.0 in
Bowl Width
10.0 in
Bowl Depth
6.0 in
Water Heater Information
This unit is equipped with a heating element to heat the fresh water. It is controlledby a built in thermostat to maintain a nominal water temperature of 110o . The unit is equipped with a float switch to turn off power to the heating element if the water level should drop too low. The unit may take up to one hour to heat the water, depending upon the temperature of the water that it is fi lled with. The system is electrically protected with a GFCI plug. If for some reason, the GFCI were to trip, simply push the reset button on the plug. If the unit trips the GFCI protection again, remove from service, and have a qualified electrician inspect the sink.
FDA Information
All materials, including resin, pigments and additives used to make the plastic components as well as the plumbing components that come in contact with the fresh water supply are U.S. Government Food & Drug Administration (FDA) food grade compliant materials. In certain geographical areas of the USA, a warning decal, "Not for Drinking or Cooking" is required. This sink is supplied with PC-000782 Warning Decal, which is located directly below the faucet. It is suggested that this decal be replaced if it becomes damaged or worn out. All dimensions are subject to change due to environmental factors.
Filling with Fresh Water
Unit must be filled prior to plugging in the heater. Unscrew the 1” fill plug located at the top, right hand side of the wash basin. Insert a standard garden or similar type hose and fill with a few gallons of fresh water to perform a system check. Depress the pump a few times to “prime” it (the pump has a built-in check valve that will hold a prime between uses). If needed, continue filling to the top (which is the 17 gallon water level capacity). Tighten the plug when fi nished.
Emptying Fresh Water
Drain the fresh water by unscrewing the 1/2” plug located at the bottom of the sink, to the left of the foot pump. Tighten the plug when finished.
Emptying Gray Water
Wheel the sink to a proper and approved drain location. Pull the hose out from the rib on the back of the holding tank, remove the hose cap and empty the gray water. Replace the cap when finished.
Please contact us with any questions.
Thank you,
EJC Ventures, LLC